Versions Compared
Key
- This line was added.
- This line was removed.
- Formatting was changed.
Preset announcements can be sent to three different targets, also called Intercom endpoints:
- In-Room - announcement directed at the simulation environment
- Facilitator - announcement sent to the facilitator's headset
- Simulator - announcement uttered by the manikin ("Voice of Patient")
Image Removed
Image Removed
Image Added
Info |
---|
The announcements can be added on the Intercom tab of the System module, then selected via the arrow in the |
Image Removed
The targetannouncement drop-down, after having highlighted the desired target (In-Room, Facilitator or both, and Simulator). The hardware assignment has to be completed in the Room Settings pop-up on the Rooms tab. |
Image Added
Image Added
The Push-to-talk button will turn green Image Added while the preset announcement is being sent out:
Image Removed
By clicking and holding any of the target buttons,Image Added
Live
announcements can also be sounded via the respective device
by selecting a target device (In-Room, Facilitator or Simulator), and then clicking and holding the Push-to-Talk button.
If there is no valid Intercom destination available in the system, the Push-to-talk button is displayed in orange color (when pushing it)Image Added and a warning message shows at the top of the page.
Image Added
If Intercom setup is not completed (e.g a destination station needs to be reconnected), the Push-to-talk button is displayed in red color (when pushing it) Image Addedand a warning message shows at the top of the page:
Info |
---|
For live announcements, microphone needs to be enabled in the browser settings. |
Note |
---|
The Intercom via Simulator function is only availabe for CAE Simulators, not for non-CAE (third-party) simulators. |
Info |
---|
Learn about Why are some of the buttons in the Intercom panel inactive? See also our Practical Recording and Recording - FAQ pages and watch our related Training Videos. |