Experience Help Site

Page tree

Versions Compared

Old Version 1

changes.mady.by.user CAE author

Saved on

compared with

New Version Current

changes.mady.by.user CAE author

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

If a camera is connected to the LearningSpace network and is ready to be used, its status is listed on the Cameras tab of the 

System module

System module as one of the following:

  • Configured: it has been added to the system as well and can be assigned to a room, that is, it will be listed in the Camera drop-down menus in the Room Settings pop-up.
  • Not Yet Configured: it is connected but still has to be added to the system by clicking the plus icon in the Controls column.

    Image Added
Info
NOTE: Configured cameras have a cogwheel icon in the Controls column, and clicking the icon prompts the Camera Settings pop-up to open where all fine-tuning can be completed.

Already configured camera unseen:

If a previously configured camera is not displayed in the Recording module, or is not available in a Camera drop-down menu in the relevant modules, it is listed on the Cameras tab as Disappeared and there is a red minus

icon the 

icon Image Added the Controls column.

Image Added

In such a case, physically check the camera device and make sure that it is connected to the network:

    1. If not, then connect it.
    2. If connected, then power off the camera, wait a minute, then power it back on.
Image Removed