Stations are computers added to the system, which are identified by their IP addresses. These computers can be used as workstations to fill out data entry or display information for a specific activity.
IMPORTANT
CAE LearningSpace assigns IP addresses dynamically to devices. The system uses the Dynamic Host Configuration Protocol, DHCP, in short.
The IP address assigned with DHCP is associated with a lease and usually has an expiration period. If the lease is not renewed, a device will be assigned a new IP address.
The IP addresses featured on the Stations tab are not dynamically updated, which means you have to add each computer whose IP address changed to the system again.
The IP address assigned with DHCP is associated with a lease and usually has an expiration period. If the lease is not renewed, a device will be assigned a new IP address.
The IP addresses featured on the Stations tab are not dynamically updated, which means you have to add each computer whose IP address changed to the system again.
Station configuration
Complete the following steps to configure a computer as a station:
- Go to System.
- Go to Stations.
- Click Add This Computer at the bottom.
The Station Manager window opens.
- Enter the name of the workstation and
- Select the function of the station.
- Hallway Station: A computer located outside but near the simulation room; for learners to submit their checklists.
- In-room Station: A computer located inside the simulation room; for SPs to submit their checklists.
Additional Station: A computer to display the door note of the activity or store the data logs of third-party simulators.
Each station type can be used to display different kinds of information about the activity.
Find out more about information display features at the Get Placard and Today's Activities pages.
Select all of the functions to use the computer as any type of workstation later on.
Save your settings.
The computer will be added to the system as a station.
The computer you are currently logged in on appears in bold and is highlighted in blue on the Stations page.
Black ticks indicate the functionality of a station, whereas greyed out ticks mean the functionality does not apply.
Decoder
Assigning a decoder to a station facilitates a low-delay display of a camera with PTZ functions via a separate monitor.
NOTE: See further details at How to Use Joystick (AXIS T8311) for PTZ Functions.
Overview
Content Tools