Enterprise Help Site

Page tree

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

Center Overview (CO) allows you to monitor multiple recordings at the same time.

Recording

With the Record control panel in CO, you can control recordings without entering the Ent Single Room View (SRV) (revised) of any of the rooms. 
To launch or stop a recording in a room, pick one from the Room drop-down menu and use the red Start Recording or blue Stop Recording buttons.

It is also possible to launch and stop recordings in multiple rooms at the same time:

  • in all rooms on the current tab = 'All rooms on this tab' or
  • all rooms available in CO = 'All rooms on all tabs'


Drop-downs in the Record control panel:

With the Record control panel in CO, you can also set up the activity, case, learner(s), and even the position of the camera (if a PTZ camera is installed in the room).
You can either apply settings to one room or multiple rooms.

Room: Select one room, all rooms on the current tab, or all rooms available in CO.

Activity: Select an activity you would like to assign to the room(s).

Case: Select a case from the chosen activity.

Learner: Select a learner you would like to assign to the recording(s), or the entire group.

Settings applied with the Record control panel override the settings in rooms where an activity, case, and possibly learners were already set up with the Activity Scheduler or RNSA (in Room Manager).

Example:

In-Room: Exam 1, Activity: EMT Assessment, Case: EMS George Davis (collapse) is already scheduled.
But, in CO, the Video Full Control user selects Room: Exam 1, Activity: Clinical Skills Assessment, and Case: CSA Chest Pain 2018 (Palpitations) in the Record control panel and launches the recoding.
The recording will no longer be registered for EMT Assessment/EMS George Davis (collapse) but for Clinical Skills Assessment / CSA Chest Pain 2018 (Palpitations), the activity and case selected in the Record control panel.

PTZ Preset: All camera positions are listed here that have been defined in rooms equipped with a PTZ camera. Select a preset position to apply it to the room it was created in.

Important

A PTZ position only applies to the room it was created in. It is not affected by the other settings (room, activity, case, and learner) featured on the Record control panel.

Tip

Would you like to apply the same PTZ preset to multiple rooms at once? Find out more about it here.




  • No labels